Harbor Freight Tools Work Light 95388 User Manual

solar spotlight with led  
bulbs  
Model 95388  
asseMbly and operation instructions  
Due to continuing improvements, actual product may differ slightly from the product described herein.  
®
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Visit our website at: http://www.harborfreight.com  
to preVent serious injury, read and understand  
all warnings and instructions before use.  
©
®
Copyright 2006 by Harbor Freight Tools . All rights reserved. No portion of this  
manual or any artwork contained herein may be reproduced in any shape or form  
without the express written consent of Harbor Freight Tools.  
for technical questions or replacement parts, please call 1-800-444-3353.  
 
11.  
12.  
warning: nicd batteries must be disposed of properly. Do not incinerate. Batteries  
may burst, causing personal injury and/or property damage. Contact your local hazardous  
waste disposal authority for proper disposal.  
People with pacemakers should consult their physician(s) before using this product. Elec-  
tromagnetic fields in close proximity to a heart pacemaker could cause interference to or  
failure of the pacemaker.  
unpacKing  
When unpacking, check to make sure that the item is intact and undamaged. If any  
parts are missing or broken, please call Harbor Freight Tools at the number shown on the  
cover of this manual as soon as possible.  
asseMbly and operating instructions  
note: For additional information regarding the parts listed in the following pages, refer to the As-  
sembly Diagram near the end of this manual.  
1.  
2.  
WARNING! Make sure the Power Button at the back of the Lamp Housing (5) is in its  
“OFF” position before making any adjustments to the Spotlight. See Figure 1.  
Decide where you want to place the Solar Spotlight. Choose a location that receives full,  
direct sunlight a minimum of six hours a day. The location should not be near nighttime  
light sources such as porch lights or streetlights as this may trigger the lights to turn off or  
flicker.  
3.  
4.  
The Solar Spotlight will need to charge for at least 6 hours before using it for the first  
time.  
The light is powered by two “AA” batteries. For directions on how to replace the batteries,  
refer to the Replacing the Batteries section on the following page.  
Figure 1  
Power Button  
Lamp Housing (5)  
5.  
6.  
Press the Power Button to the “On” position-see Figure 1.  
Pressing the Power Button will automatically turn on the Solar Spotlight during the  
night. After the initial charge is set, check to see that the LED Lights (2) are on by  
viewing the light at night or in a dark location.  
SKU 95388  
for technical questions, please call 1-800-444-3353.  
Page 3  
 
note: During the day, the Solar Panel converts sunlight into electricity, recharging the  
batteries. The amount of light the Solar Panel receives depends on placement of  
the Solar Spotlight, geographic location and weather. If the weather is cloudy and  
the panel did not receive a full charge, the Solar Spotlight may not achieve the full  
hours of operating time. It will catch up on its own after two to three days of full  
sun.  
inserting the ground stake (11):  
1.  
Insert the Connecting Shaft Screw (7) into the hole on the Connecting Shaft (6).  
Slide the Connecting Shaft 2 (9) onto the Shaft Screw (7) so that Connecting Shaft  
(6) and Connecting Shaft 2 (9) are fitted together. Thread on Nut (10) to secure in  
place.  
2.  
3.  
Insert Ground Stake (11) up into the Connecting Shaft 2 (9).  
warning: Before inserting the Solar Spotlight into the ground, make certain to  
choose an area where there are no underground pipes, cables or other obstructions.  
Make certain that the ground is soft enough to accept the Ground Stake (11). Gently  
insert the Ground Stake (11) into the ground making certain that it is in solid. Make  
certain that the Stake is completely inserted into the ground to assure full stability  
for the Solar Spotlight.  
4.  
The Lamp Housing (5) rotates up and down to obtain the best lighting situation.  
The Solar Panel (1) pivots on a ball and can be set to a number of different angles  
to obtain the best angle for solar power.  
replacing the batteries  
1.  
2.  
It is recommended that you replace the batteries every 12 months. Before perform-  
ing any maintenance on the Spotlight, make certain that the Power Button is in the  
OFF position.  
To access the batteries, twist the Lamp Cover (22) and remove it from the Lamp  
Housing (5). Then remove the Transparent Cover (21) and Reflecting Bowl (20)  
from the Housing (5). The Battery Housing (17) and Batteries (16) are attached to  
the Reflecting Bowl (20). See Figure 2, next page.  
3.  
Remove the old Batteries (16). Make certain that the new batteries are “AA” , Ni-Cd  
rechargeable. Install the new batteries into the Battery Housing (17). Make certain  
that the batteries are placed according to the correct polarity. Insert the Battery  
Housing (17) and Reflecting Bowl (20) back into the Lamp Housing (5). Place the  
Transparent Cover (21) back over the Reflecting Bowl (20) and screw the Lamp  
Cover (22) back over the Lamp Housing (5).  
SKU 95388  
for technical questions, please call 1-800-444-3353.  
Page 4  
 
Lamp Cover (22)  
Reflecting Bowl (22)  
Figure 2  
Batteries (16)  
Maintenance  
1.  
Clean regularly with a damp towel. Do not use any type of solvent for cleaning. Do  
not put too much pressure on the light or components while cleaning. Dry thor-  
oughly.  
parts list  
Part  
1
Description  
Solar Panel  
Q’ty Part  
Description  
Button Cover  
Power Button  
Circuit Board  
Q’ty  
1
1
1
2
2
12  
13  
14  
2
Solar Panel Frame  
Screw 1  
1
3
1
4
Rotation Bracket  
15 Circuit Board  
Screw  
1
5
6
Lamp Housing  
Connecting Shaft 1  
Connecting Shaft Screw  
Screw 2  
1
1
1
1
1
1
16  
17  
18  
19  
20  
Batteries  
Battery Housing  
Screw 3  
2
1
1
3
1
1
7
8
LED  
9
Connecting Shaft 2  
Nut  
Reflecting Bowl  
10  
21 Tr a n s p a r e n t  
Cover  
11  
Ground Stake  
1
22  
Lamp Cover  
1
SKU 95388  
for technical questions, please call 1-800-444-3353.  
Page 5  
 
please read the following carefully  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEM-  
BLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER  
OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER  
THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR  
SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER  
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS  
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE  
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS  
TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS  
asseMbly diagraM  
SKU 95388  
for technical questions, please call 1-800-444-3353.  
Page 6  
 

Graco Baby Accessories PD162117C User Manual
Greenheck Fan Humidifier HRE 20 User Manual
Greenway Home Products Indoor Fireplace MM281COK User Manual
HANNspree Flat Panel Television S_ST55F_UM_EU_V01_H User Manual
Harbor Freight Tools Hunting Equipment 67802 User Manual
Hotpoint Range JB400DP1BB User Manual
HP Hewlett Packard Digital Camera M307xi User Manual
HP Hewlett Packard Personal Computer A2W44UT#ABA User Manual
HP Hewlett Packard Printer 2280TN User Manual
Husqvarna Chainsaw 136 141 136LE 141LE User Manual